Filtyp
Soneji-ICT-Sustainability.dvi Lund University LUMES Masters Thesis Connected Consequences: Resource Depletion and North-South Inequities of the Global Material Intensity of the Internet and Mobile Telephony Author: Hitesh Soneji Lund University Masters in Environmental Studies and Sustainability Science hitesh@sonejifamily.org Supervisor: Dr. Mats Svensson Lund University Centre for Sustainability
https://www.lumes.lu.se/sites/lumes.lu.se/files/soneji_hitesh_0.pdf - 2026-04-30
Poster_AMNL Quantum size eect in 2D spectroscopy of CdSe quantum dots ACKNOWLEDGEMENTS 1. Division of Chemical Physics and Nano Lund, Lund University, P.O. Box 124, 22100, Lund, Sweden. 2. ELI Beamlines, Za Radnicí 835, 252 41 Dolní Břežany, Czech Republic. REFERENCES 1) M. Lard, ten Sietho, L., Generosi, J., Månsson, A., Linke, H., Nano Lett., 2014, 14(6). 2) L. ten Sietho, Lard, M., Generosi, J.
Background: Little is known regarding treatment with cangrelor during percutaneous coronary intervention (PCI) in patients with myocardial infarction complicated by cardiogenic shock or cardiac arrest. Objectives: The aim of this study was to investigate the effects of such cangrelor treatment during PCI in patients with myocardial infarction complicated by cardiogenic shock or cardiac arrest. Met
OBJECTIVES: The referrals of elderly for cardiac surgery are increasing. The aim of this retrospective study is to review the long-term survival and to identify causes of late death in elderly after cardiac surgery. DESIGN: Between 1990 and 1993, 130 octogenarians underwent cardiac surgery in our department. A majority (88%) had elective surgery. One hundred and nine patients (84%) were in New Yor
BACKGROUND: If lungs from subjects dying of heart attacks could be used for transplantation, the lung donor shortage could be radically reduced. The aim of this study was to investigate, in an experimental survival model, the results of lung transplantation using lungs from non-heart-beating donors. METHODS: The left lung, topically cooled to 25 degrees C for 2 hours in situ after 5 minutes of cir
The objective of this prospective study of matched controls was to find out whether supplementary nutrition would improve wound healing and decrease mortality in patients undergoing transtibial amputation for occlusive arterial disease. The nutritional status of 32 consecutive transtibial amputees was assessed and 28 were classified as malnourished. Supplementary nutrition was given reaching an av
OBJECTIVE: The potential association between thyroid hormones and breast cancer has been investigated in a large number of studies without conclusive results. This study investigated T3 levels in relation to breast cancer mortality in a population with no breast cancer patients at baseline. An additional aim was to study T3 levels in relation to mortality from other cancers and all-cause mortality
The purpose of our study was to develop specific, sensitive, objective assays for early detection of disseminated tumour cells in patients with colorectal cancer (CRC). Carcinoembryonic antigen (CEA) and cytokeratin 20 (CK20) were chosen as markers because they are selectively expressed in epithelial cells with maintained expression in CRC. Real-time quantitative RT-PCR assays with RNA copy standa
Objectives: To describe and evaluate the two-year outcome on cognition (MMSE, ADAS-cog) and global rating (CIBIC) of galantamine treatment in Alzheimer’s disease (AD) in a routine clinical setting. Methods: The Swedish Alzheimer Treatment Study (SATS) is an open, longitudinal, multicenter study evaluating cholinesterase inhibitor (ChEI) treatment in AD. Patients are investigated at baseline, at 2
Background: We aimed to explore the effects of polypharmacy and specific drug classes on readmissions and mortality after hip surgery. Methods: We analyzed data on 272 consecutive hip fracture patients (72.1% females; age 82±9 years) who underwent acute hip replacement. We collected detailed data on the pharmacological treatment upon admission and discharge. Patients were followed up over a period
() Requirements Bo Bernhardsson and Karl Johan Åström Department of Automatic Control LTH, Lund University Bo Bernhardsson and Karl Johan Åström Requirements Requirements and Limitations 1 Introduction 2 The basic feedback system 3 A broad view of control system design 4 Command signal following - System inversion 5 Disturbances 6 Process uncertainty 7 Robustness 8 Summary Theme: Requirements
https://www.control.lth.se/fileadmin/control/Education/DoctorateProgram/ControlSystemsSynthesis/2016/Requirements.pdf - 2026-04-28
Decision on exemptions from specific points in the List of Rights – Lund University Students’ Rights and Responsibilities – School of Economics and Management Page 1 of 4 Student Affairs Education Strategy Support Oskar Cornelius, Policy Officer DECISION Reg. No. STYR 2022/1347 Date 2 September 2024 Recipient Education Board Decision on exemptions from specific points in the List of Rights – Lund
Test "Title" ORNIS SCANDINAVICA 15: 63-66. Copenhagen 1984 Removal experiments in a population of Willow Warblers Phylloscopus trochilus in mountain birch forest, in Ammarnas, Swedish Lapland Bjorn Arvidsson and Per Klaesson Arvidsson, B. and Klaesson, P. 1984. Removal experiments in a population of Willow Warblers Phylloscopus trochilus in mountain birch forest, in Ammarnis, Swedish Lapland. - Or
https://www.luvre.lu.se/sites/luvre.lu.se/files/luvre-058arvidssonmfllosanremoval.pdf - 2026-04-30
Centre for Economic Demography Lund University School of Economics and Management P.O. Box 7083 SE-220 07 Lund, Sweden www.ed.lu/publications/Lund-Papers-in-Economic-Demography/ Do grandfathers really matter for social mobility? Evidence from Swedish register data JONAS HELGERTZ, MARTIN DRIBE LUND PAPERS IN ECONOMIC DEMOGRAPHY 2019:1 Copyright is held by the author(s). Lund Papers in Economic Demo
https://www.lusem.lu.se/sites/lusem.lu.se/files/2024-07/LPED_2019_1.pdf - 2026-04-29
Name Organisation Email (required) I would like to participate in the event Participate? (required) Subscribe? Please add me to the AI Lund sendlist Please read the policy and regulations that guide how Lund University processes personal data in this context.AI Lund policy on personal dataLund University privacy policy I am aware of the regulations and policies that guide how Lund University proce
https://www.ai.lu.se/2026-06-17/registration - 2026-04-29
Name Organisation Email (required) I would like to participate in the event Participate? (required) Subscribe? Please add me to the AI Lund sendlist Please read the policy and regulations that guide how Lund University processes personal data in this context.AI Lund policy on personal dataLund University privacy policy I am aware of the regulations and policies that guide how Lund University proce
https://www.ai.lu.se/2026-06-10/registration - 2026-04-29
Name Organisation Email (required) I would like to participate in the event Participate? (required) Subscribe? Please add me to the AI Lund sendlist Please read the policy and regulations that guide how Lund University processes personal data in this context.AI Lund policy on personal dataLund University privacy policy I am aware of the regulations and policies that guide how Lund University proce
https://www.ai.lu.se/2026-08-26/registration - 2026-04-29
Name Organisation Email (required) I would like to participate in the event Participate? (required) Subscribe? Please add me to the AI Lund sendlist Please read the policy and regulations that guide how Lund University processes personal data in this context.AI Lund policy on personal dataLund University privacy policy I am aware of the regulations and policies that guide how Lund University proce
https://www.ai.lu.se/2026-06-03/registration - 2026-04-29
Division of Production and Materials Engineering Our research laboratory is situated in M-building, at the south end of the campus of the Faculty of Engineering in Lund. In total the laboratory encompasses 1000 square meter that can highlight most parts of modern production, from injection moulding of plastics to deep-drawing of sheet metal, even if our main research is connected to metal cutting.
https://www.ims.lth.se/en/about/production-and-materials-engineering/infrastructure - 2026-04-29
