Filetype
This paper derives a generic model for the multiple-input multiple-output (MIMO) wireless channel. The model incorporates important effects, including i) interdependency of directions-of-arrival and directions-of-departure, ii) large delay and angle dispersion by propagation via far clusters, and iii) rank reduction of the transfer function matrix. We propose a geometry-based model that includes t
Abstract is not available
Objectives: To evaluate the use of cellular and cordless telephones as the risk factor For non-Hodgkin's lymphoma (NHL). Methods: Male and female subjects aged 18-74 years living in Sweden were Included during a period from I December 1999 to 30 April 2002. Controls were selected from the national population registry. Exposure to different agents was assessed by questionnalre. Results: In total, 9
Hosts can in principle employ two different strategies to defend themselves against parasites: resistance and tolerance. Animals typically exhibit considerable genetic variation for resistance (the ability to limit parasite burden). However, little is known about whether animals can evolve tolerance (the ability to limit the damage caused by a given parasite burden). Using rodent malaria in labora
The objective of this paper is to investigate how the combustion chamber design will influence combustion parameters and emissions in a natural gas SI engine. Ten different geometries were tried on a converted Volvo TD102 engine. For the different combustion chambers emissions and the pressure in the cylinder have been measured. The pressure in the cylinder was then used in a one-zone heat-releas
Thermal radiation sometimes is the dominating heat transfer mode in combustion chambers and furnaces and therefore in the design of many relevant industrial facilities prediction of it is necessary. During previous years many research efforts in the radiative heat transfer field have originated and many methods and models from simple to complex have been developed. However, the field is still open
The basic ideas of k(t)-factorization and CCFM parton evolution is discussed. The unintegrated gluon densities, obtained from CCFM fits to the proton structure function data at HERA are used to predict hadronic final state cross-sections like jet production at HERA, but also comparisons with recent measurements of heavy quark production at the Tevatron are presented. Finally, the k(t)-factorizatio
New strategies for prevention and treatment of type 2 diabetes (T2D) require improved insight into disease etiology. We analyzed 386,731 common single-nucleotide polymorphisms (SNPs) in 1464 patients with T2D and 1467 matched controls, each characterized for measures of glucose metabolism, lipids, obesity, and blood pressure. With collaborators (FUSION and WTCCC/UKT2D), we identified and confirmed
An increasing incidence of testicular cancer has been reported from several western countries during the last decades. According to current hypothesis testicular cancer is initiated during the foetal period and exposure to endocrine disruptors such as some persistent organic pollutants has been of concern. We have previously reported the results for concentrations of polychlorinated biphenyls (PCB
A non-associated plasticity theory for granular materials has been developed in Part 1 based on the concept of a characteristic stress state of vanishing incremental dilation. The model is fully three-dimensional and is defined by six material parameters: two for elastic stiffness, one for plastic stiffness, two for the shapes of yield and plastic potential surfaces and one for the dilation at fai
We present an experimental comparison of magnetoconductance fluctuations measured in the ballistic, quasiballistic, and diffusive scattering regimes of semiconductor devices. In contradiction to expectations, we show that the spectral content of the magnetoconductance fluctuations exhibits an identical fractal behavior for these scattering regimes and that this behavior is remarkably insensitive t
Two hundred apparently healthy sexually active women, 17-34 years of age, who had presented for a general health check-up at the Clinic of Dermatology and Venereology, Medical University, Plovdiv, Bulgaria, were asked about genital symptoms, sexual behaviour, contraceptive use and smoking habits, and examined for signs of genital infections. They were searched for genital chlamydial infection, gon
This thesis has two values. On one side, it aims at being a contribution to a betterunderstanding of the original concept of distributed economies. On the other side, it aspires atproviding useful decision criteria to those stakeholders that plan to locally develop a biogassystem.This thesis is developed from the Distributed Economies concept, which envisionsdecentralized, self-reliant and synergi
Parallel kinematik machines are nowadays an important branch of investigation in the robotics field. Its design allows for high speeds, accelerations and tool forces as well as makes them ideals for faster cycle times and high repeatability works. TAU is a parallel kinematic machine from ABB Company with three degrees of freedom. Therefore, it can be positioned anywhere of the workspace but not or
Objective: The objectives set out for this Master Thesis were: · How should a coffee machine for home use be designed and which features should the machine provide? · How should an experimental prototype be manufactured? · How should an experimental prototype be tested? Method: The thesis is written as a product development report and essentially follows the methods described by Ulrich and Eppinge
Formula Student is an international inter-universities competition about designing and building a single-seater racing car. One of the most important parts in a car is the suspension system, from the tires to the shock absorbers. This Master Thesis’ report goes through all these parts, looking to theory, different design options, the constraints (rules, economical, packaging, etc) and the final de
The Republic of Moldova is celebrating 20 years of independence and is still almost completely dependent on energy imports from the Russian federation. Renewable energy is in its infancy despite a climate that is well suited for solar and wind energy with 2,300 sunshine hours per year and measured wind speeds up to 8.5 m/s. Moldova has a history of wine production and wide spread usage of more tha
A new optical interferometer for delay stabilization in attosecond pump/probe experiments is constructed, featuring a custom-made hole-drilled recombination mirror and using a co-propagating HeNe laser for the interference. The interferometer is shown to generate an interference pattern of high enough contrast for delay stabilization. The stability of the measured delay is tested with the interfer
